Digimerge DPV24TLXR Manuel d'instructions télécharger pdf (Page 13)

-8-

INSTALLATION. INDOOR DOME (Surface Mounting)

1a) Press down on the tab marked with an arrow to lift

up the dome cover slightly

1b) While pressing on tab, twist the dome cover

counter clockwise just a few degrees to release

dome cover from back clips.

Lift off the cover.

3a) Reinsert camera module into camera base by

aligning the arrow notches, and turning camera

module clockwise to lock into place.

3b) Reinstall the base locking screws. (indicated

by padlock markings)

Go to step

on page 9 to complete installation.

Method 1 - Direct Attach Install

2a) Use included mounting template to mark and pre-

drill the required holes. Use included 2.8” screws to

mount the camera directly to the mounting surface.

Go to step

on page 9 to complete installation.

Method 2 - Camera Base Install

2b) Use the included mounting template (Installation

Option 1) to mark and pre-drill the required holes.

Remove the camera base by unscrewing the base

locking screws (indicated by padlock markings)

and turn camera module approx. 5 degrees

counterclockwise to detach camera base from the

camera module. Install the base as indicated using

the 1.2” screws. Go to step 3a.

Method 3 - Junction Box Install

2c)

(see page 4 for details). Remove the camera

base by unscrewing the 3 base locking screws,

and turn the camera module approx. 5 degrees

counterclockwise to detach camera base from

camera module. Install the base to the junction box

using the base attachment screws. Go to step 3a.

ATTENTION - If using DC power, follow the correct

polarity as marked on the power cable.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 31 32

Pas de commentaire

Digimerge DPV24TLXR Manuel d'instructions Page 13