Digimerge DH200 Instructions d'exploitation télécharger pdf (Page 150)

140

Appendix J: Replacing the Hard Drive

Replacing the Hard Drive

To replace the hard disk:

1. Carefully position the new hard drive on the four rubber mounting feet in the housing. The

onnections end of the hard drive should face the data and power cables.

2. With your hand supporting the hard drive, r

eplace the four mounting screws underneath the

housing.

3. Reconnect the cables to the hard disk. Make

sur

e the cables are connected firmly.

4. Carefully replace the cover over the housing

and slide to

wards the front panel. The cover

should be flush on all sides.

5. Replace the screws on the rear panel: 3 short

scr

ews at the corners, 1 longer screws at the

top, and 4 longer screws along the video ports.

6. Replace the short screws on the side panels.

7. Reconnect all cameras and cables. Re-mount

the

unit the back of your monitor if desired.

8. Power on the system. If you have installed a

w hard disk, you must format the hard disk

before using the system.

Figure 44.2 Place the HDD on the rubber mounting feet

Figure 44.3 Reconnect the power and data cables

1 2 ... 145 146 147 148 149 150 151 152 153 154 155 ... 163 164

Pas de commentaire

Digimerge DH200 Instructions d'exploitation Page 150