Digimerge DPD34D Manuel d'instructions télécharger pdf (Page 12)

-7-

INSTALLATION. VANDAL DOME

7a) Re-attach the dome cover. Align arrows according to the

diagram below to ensure a weatherproof seal.

7b) Use the allen key to tighten the tamper screws.

Note: Make sure dome cover cord does not get caught in

the rubber seal.

6a) Adjust camera viewing angle and secure into

place by tightening thumb screw using a at head

screwdriver.

Note: Lens adjustment levers are by default in the

locked position. Turn counter clockwise to unlock.

Tighten levers to secure lens setting.

6b) Adjust lens and OSD as required.

6c) Re-attach the camera cover, using the thumb screw

as a guide, until it snaps into place.

5) Insert the included video test cable into the RCA jack and

connect to a test monitor to set up camera.

4) Remove camera cover by squeezing the back and front

of the cover (as indicated by the arrow indicators) at the

same time and lifting it up and away from the lens.

Arrow

Video test cable

RCA Jack

Zoom

Thumb Screw

Focus

Arrow on camera base

Correct arrow alignment

Arrow on camera module (inside camera)

Arrow on dome cover.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 31 32

Pas de commentaire

Digimerge DPD34D Manuel d'instructions Page 12